Savana 2500 V8-6.6L DSL Turbo (2008)
4. Install the washer.
Important: Do not reuse the pinion nut.
5. Install the new pinion nut.
6. Install the J 8614-01 onto the pinion yoke as shown.
Notice: Refer to Fastener Notice .
7. Tighten the pinion nut while holding the J 8614-01 .
Tighten the pinion nut to 339 N.m (250 lb ft).
8. Install the propeller shaft to the rear axle pinion yoke. Refer to One-Piece Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/One-Piece Propeller Shaft Replacement) or Two-Piece Propeller Shaft Replacement (See:
Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement) .
9. Inspect and add axle lubricant to the axle housing, if necessary. Refer to Rear Axle Lubricant Level Inspection (8.6 Inch Axle) (See: Fluid -
Differential/Service and Repair/Procedures/Rear Axle Lubricant Level Inspection (8.6 Inch Axle))Rear Axle Lubricant Level Inspection (9.75,
10.5 and 10.75 Inch Axle) (See: Fluid - Differential/Service and Repair/Procedures/Rear Axle Lubricant Level Inspection (9.75, 10.5 and 10.75
Inch Axle)) .
10. Lower the vehicle.
