Savana 2500 V8-6.6L DSL Turbo (2008)
Constant Velocity Joint: Service and Repair
Wheel Drive Shaft Inner Joint and Boot Replacement
Wheel Drive Shaft Inner Joint and Boot Replacement
Tools Required
*
J 8059 Snap Ring Pliers
*
J 43218 Clamp Pliers - Narrow Jaw
*
J 46588 Axle Seal Crimp Tool
Removal Procedure
1. Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (See: Service and Repair) .
2. Remove the large clamp (4) and the small clamp (7). Use a side cutter or other suitable tool and discard the clamps.
3. Remove the tripot housing (1) from the wheel drive shaft.
4. Compress the tripot seal up the wheel drive shaft bar, away from the tripot spider assembly toward the outboard end of the wheel drive shaft
assembly.
