Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Removal Procedure
1. Remove the armrest from the seat back.
2. Remove the center seat belt retractor, if equipped.
3. Release the J channel Fastener at the bottom edge of the seat back cover (3).
4. Release the hook and loop strips that retain the seat back cover to the seat back foam pad (2).
5. Working from side to side, carefully lift the seat back cover from the foam pad.
6. Remove the foam pad (2) from the seat back frame (1).
Installation Procedure
1. Position the foam pad (2) to the seat back frame (1).
2. Working from side to side, install the seat back cover (3) over the foam pad (2).
3. Engage the hook and loop strips that retain the seat back cover to the seat back foam pad.
4. Engage the J channel fastener at the bottom edge of the seat back cover.
5. Install the center seat belt retractor, if equipped.
6. Install the armrest to the seat back.
Rear Seat Back Replacement
Rear Seat Back Replacement
Removal Procedure
1. Remove the rear seat from the vehicle.
2. Remove the seat back cover and pad.
Important: Note the position and the length of the bolts removed. This will assist with reassembly.
3. Remove the right and left bolts that retain the seat back frame to the seat back hinges.