Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
18. Remove the main connector bracket bolts.
19. Reposition the engine wiring harness out of the way.
20. Prior to removing the fuel injector pipes, use compressed air to blow any debris from between the injector line and fittings. Wipe the fittings clean
of debris.
21. Spray lithium grease between the fuel injector line and fittings to assist in containing any debris during removal. Refer to Sealers, Adhesives, and
Lubricants.
Notice: DO NOT use compressed air to clean debris from the fuel injector inlet after the fuel line is removed. Using compressed air can allow
debris to enter the fuel injector inlet and damage the fuel injector.
22. Remove the right fuel injector pipes.
