Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
6. If replacing the lower oil pan perform the following steps, otherwise proceed to step 4 in the installation procedure.
7. Remove the oil level sensor retaining clip (3).
8. Remove the oil level sensor bolt (2) and sensor (1).
Installation Procedure
1. If the lower oil pan was replaced perform the following steps, otherwise proceed to step 4.
Important: When routing the oil level sensor wire, ensure that the wire is routed along the side of the oil pan.
Notice: Refer to Fastener Notice.
2. Install the oil level sensor (1) and bolt (2).
Tighten the bolt to 9 N.m (80 lb in).
3. Install the oil level sensor retaining clip (3).
