Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
6. Remove the discharge hose nut from the condenser.
7. Remove the discharge hose from the condenser.
8. Remove the discharge hose from the vehicle.
9. Discard all of the used sealing washers. Cap the system openings.
Installation Procedure
1. Install the discharge hose to the vehicle.
2. Install new sealing washers to the discharge hose.
3. Install the discharge hose to the condenser.
Notice: Refer to Fastener Notice.
4. Install the discharge hose to condenser retaining nut.
Tighten the nut to 16 N.m (12 lb ft).