Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Caution: Refer to Restraint System Service Precautions.
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the battery negative cable(s).
2. Remove the right knee bolster.
3. Remove the body control module (BCM).
4. Disable the SIR system. Refer to SIR Disabling and Enabling.
5. Remove the left knee bolster.
6. Remove the left knee bolster bracket.
7. Remove the steering column.
8. Remove the instrument panel (I/P) cluster trim plate bezel.
9. Remove the instrument cluster assembly.
10. Remove the left hinge pillar trim panel.
11. Remove the right hinge pillar trim panel.
12. Remove the right knee bolster bracket.
13. Remove the passenger side SIR module.
14. Remove the I/P upper trim pad.
15. Remove the engine cover.
16. Remove the radio and mounting bracket, if equipped.
17. Remove the I/P compartment, if equipped.
18. Remove the heater and the A/C control.
19. Remove the steering column wiring harness from the instrument panel carrier.
20. Remove the bolts that retain the I/P carrier to the vehicle.
21. Rotate the I/P carrier out and downward in order to gain access to the HVAC ducts and the electrical harness.
22. Remove the bolts that retain the air ducts to the I/P carrier.
23. Remove the HVAC air distribution duct from the I/P carrier.
24. Remove the wiring harness from the I/P carrier.
25. Remove the I/P carrier from the vehicle.
Installation Procedure
