Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
5. Remove the I/P upper trim pad (2) from the vehicle.
Installation Procedure
1. Slide the I/P upper trim pad (2) forward in order to engage the front hooks of the I/P upper trim pad (2) to the I/P carrier.
Notice: Refer to Fastener Notice.
2. Install the I/P upper trim pad screws (1, 3).
Tighten the I/P upper trim pad screws to 3 N.m (18 lb in).
3. Install the cluster trim plate bezel.
4. Install the left and right windshield garnish moldings.
Passenger Knee Bolster Bracket Replacement
Passenger Knee Bolster Bracket Replacement
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
1. Remove the knee bolster trim panel.
2. Remove the body control module (BCM).
3. Remove the nuts (1) securing the knee bolster bracket to the instrument panel (I/P).
4. Remove the knee bolster bracket (2).
Installation Procedure
1. Align the knee bolster bracket (2) to the I/P.
Notice: Refer to Fastener Notice.
2. Install the nuts (1).
Tighten the nuts (1) to 10 N.m (88 lb in).