Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Fuel Injector: Service and Repair
Fuel Injector Replacement (Left)
Fuel Injector Replacement (Left)
Tools Required
*
EN-47909 Injector Bore and Sleeve Cleaning Kit
*
J-46594 Fuel Injector Puller
Removal Procedure
1. Remove the upper fan shroud.
2. If equipped, remove the auxiliary generator. Refer to Auxiliary Generator Replacement
3. Remove the glow plug module and bracket.
4. Remove the injector/glow plug wire harness retaining bolt at lower upper valve cover.
5. Remove the fuel feed/return line bracket and bolt located under the glow plug mount bracket.
6. Disconnect the left engine wiring harness connector.
7. Remove the engine wiring harness to bracket bolt, the 2 engine wiring harness bracket to upper valve cover bolts and remove the bracket (1).
Important:
*
Prior to removal of the fuel injector pipes, use compressed air to remove any debris from the injector line and fittings.