Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
5. Install the steering shaft seal (3) onto the steering shaft assembly.
6. Install the inner boot seal (4) onto the steering shaft assembly.
7. Install the linear shift assembly.
8. Install the A/T shift lock control.
9. Put the shift lever clevis into the NEUTRAL position.
10. Adjust the A/T shift lock control by performing the following procedure:
1. Pull out the tab (1) on the adjuster block side (2) of the A/T shift lock control.
2. Press on the adjuster block (2) to compress the internal adjuster spring which disengages the adjuster teeth.
3. Slide the adjuster block (2) as far away from the solenoid as possible.
4. Push inward on the tab (1) in order to lock the adjuster block in place.
11. Inspect the A/T shift lock control for the following conditions:
1. The A/T shift lock control must lock the shift lever clevis when the shift lever clevis is put into the PARK position.
Once the steering column is installed in the vehicle, the gear shift lever must remain in the PARK position unless the brake pedal is depressed.
2. The solenoid will be energized.
12. Readjust the A/T shift lock control if needed.
