Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
10. Adjust the A/T shift lock control by performing the following procedure:
1. Pull out the tab (1) on the adjuster block side (2) of the A/T shift lock control.
2. Press on the adjuster block (2) to compress the internal adjuster spring which disengages the adjuster teeth.
3. Slide the adjuster block (2) as far away from the solenoid as possible.
4. Push inward on the tab (1) in order to lock the adjuster block in place.
11. Inspect the A/T shift lock control for the following conditions:
1. The A/T shift lock control must lock the shift lever clevis when the shift lever clevis is put into the PARK position.
Once the steering column is installed in the vehicle, the gear shift lever must remain in the PARK position unless the brake pedal is depressed.
2. The solenoid will be energized.
12. Readjust the A/T shift lock control if needed.
Caution: Refer to SIR Inflator Module Coil Caution .
Important: Rest the electrical contact of the turn signal and multifunction switch assembly on the turn signal cancel cam assembly.
13. Install the turn signal and multifunction switch assembly onto the steering column housing assembly.
14. Screw the 2 pan head tapping screws into the turn signal and multifunction switch assembly.
Tighten the screws to 1 N.m (9 lb in).
15. Install the ignition lock cylinder case.
16. Install the ignition lock cylinder.
17. Install the shift lever assembly.
18. Enable the SIR system. Refer to SIR Disabling and Enabling .
