Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Notice: Refer to Fastener Notice .
3. Install the shift lever screw (3) into the shift lever assembly (4).
Tighten the screw to 20 N.m (15 lb ft).
4. Slide the shift lever seal (2) down the shift lever assembly (4).
5. Align the shift lever seal into the steering column trim covers.
6. If necessary, install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
7. Enable the SIR system. Refer to SIR Disabling and Enabling .
Steering Column Replacement
Steering Column Replacement
Tools Required
J 42640 Steering Column Anti-Rotation Pin
Removal Procedure
Caution: Refer to SIR Caution .
1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
2. Remove the knee bolster.
Notice: The front wheels of the vehicle must be maintained in the straight ahead position and the steering column must be in the LOCK position
before disconnecting the steering column or intermediate shaft. Failure to follow these procedures will cause improper alignment of some
components during installation and result in damage to the SIR coil assembly.
3. Lock the steering column through the access hole in the lower steering column trim cover using the J 42640 .
4. Disconnect the transmission shift cable (1) from the column.
