Savana 2500 2WD V6-4.3L VIN X (2004)
6.1.
Install the J 23523-F plate and bolts onto the crankshaft balancer.
^ Tighten the bolts to 25 Nm (18 ft. lbs.).
6.2.
Install the J 23523-F forcing screw into the plate.
6.3.
Rotate the J 23523-F forcing screw clockwise in order to remove the crankshaft balancer.
7. Remove the J 23523-F from the crankshaft balancer.
8. Note the position and length of any front groove pins (crankshaft balancer), if applicable.
9. Clean and inspect all parts.
Installation Procedure
1. Apply a small amount of grease to the crankshaft front cover oil seal sealing surface.
2. Look to ensure that the front groove pin (crankshaft balancer) is installed in the proper location if applicable.
The length and location of the pins must be the same as the original length and location.
3. Apply a small amount of adhesive GM P/N 12346141 (Canadian P/N 1093433) or equivalent onto the crankshaft balancer keyway in order to seal
the crankshaft balancer keyway and crankshaft joint.
