Savana 2500 2WD V6-4.3L VIN X (2004)
2. Use a long screw driver in order to align the oil pump drive shaft to the drive tab of the distributor.
3. Guide the distributor into the engine. Ensure the flat portion of the distributor housing is facing toward the front of the engine.
4. Once the distributor is fully seated, the rotor segment should be aligned with the pointer cast into the distributor base.
If the rotor segment does not come within a few degrees of the pointer, repeat the procedure in order to achieve the proper alignment.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the distributor mounting clamp bolt.
