Savana 2500 2WD V6-4.3L VIN X (2004)
1. Assemble the new O-rings into the inlet and outlet of the fuel injector assembly.
CAUTION: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the
risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings
located in the female connector will swell and may prevent proper reconnection if not lubricated.
2. Apply a few drops of clean engine oil to the male tube ends.
3. Install the fuel feed and return pipes to the injector assembly.
4. Install the fuel pipe retainer and the attaching nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the retaining bolt to the rear fuel pipe bracket.
Tighten
1. Tighten the bracket bolt to 6 N.m (53 lb in).
2. Tighten the retainer nuts to 3 N.m (27 lb in).
