Savana 2500 2WD V6-4.3L VIN X (2004)
3. Install the new O-ring seals on the engine fuel feed and the return pipes.
4. Install the chassis fuel feed and return pipes (3) to the engine compartment fuel feed and return pipes (4).
Tighten
Tighten the fuel pipe nuts to 27 N.m (20 lb ft).
5. Install the retainer nut to the fuel and EVAP pipe.
Tighten
Tighten the retainer nut to 28 N.m (21 lb ft).
6. Tighten the fuel filler cap.
7. Connect the negative battery cable.
8. Inspect for leaks:
8.1.
Turn ON the ignition for 2 seconds.
8.2.
Turn OFF the ignition for 10 seconds.
8.3.
Turn ON the ignition.
8.4.
Inspect for fuel leaks.
9. Install the air cleaner outlet duct.
Chassis (Engine to Fuel Filter)
FUEL HOSE/PIPES REPLACEMENT - CHASSIS (ENGINE TO FUEL FILTER)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Disconnect the fuel feed and return pipes (3) from the engine compartment fuel pipes (4).
