Savana 2500 2WD V6-4.3L VIN X (2004)
Ignition Control Module: Service and Repair
IGNITION CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the engine cover.
2. Disconnect the electrical connector (3).
3. Remove the screws (4) holding the ignition control module (2) and the heat sink (1) to the bracket.
4. Remove the ignition control module and the heat sink.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the ignition control module (2) and the heat sink (1) on the bracket with the screws (4).
Tighten
Tighten the screws to 3.5 N.m (31 lb in).
2. Reconnect the electrical connectors (3).
3. Install the engine cover.
