Savana 2500 2WD V6-4.3L VIN X (2004)
1. Install the power steering cooler to the vehicle.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the power steering cooler mounting bolts.
-
Tighten the bolts to 5 Nm (44 inch lbs.).
3. Connect the power steering cooler hose to the power steering gear.
-
Tighten the hose fitting to 33 Nm (24 inch lbs.).
4. Connect the power steering cooler hose to the power steering pump.
5. Bleed the power steering system.
6. Remove the drain pan from under the vehicle.
With RPO Code GT5
Power Steering Cooler Pipe/Hose Replacement (GT5)
Removal Procedure