Savana 2500 2WD V6-4.3L VIN X (2004)
8. Wrap the bearing caps with tape in order to prevent the loss of the needle bearings.
9. Slide the rear inner tube (5) out of the outer tube (6) and remove the propeller shaft.
Installation Procedure
1. Clean the splines of the rear inner tube (6) and the outer tube (1).
2. Inspect the outer and inner splines for damage. Replace the propeller shaft assembly if necessary.
3. Apply grease, GM P/N 12345879 (Canadian P/N 109535511) or equivalent, to the splines of the rear inner tube (6).
4. Install the bushing (3) on the outer tube (1). The flanged end of the bushing should be toward the rear of the vehicle.
5. Install the 81.5 mm clamp (5) onto the rear inner tube (6). The size is stamped on the clamp.
6. Install the 86.5 mm clamp (2) on the large diameter end of the boot (4). The size is stamped on the clamp.
7. Slide the boot (4) onto the rear inner tube (6), small diameter end toward the rear of the vehicle.
8. Install the 81.5 mm clamp (5) onto the boot (4).
Important: The rear inner tube and outer tube splines are not keyed. It is important to observe the alignment marks made during removal during the
installation process.
9. Utilizing the alignment marks made during removal, reassemble the rear inner tube to the outer tube.
10. Wipe off the excess grease from the tubes.
