Savana 2500 2WD V8-5.3L VIN T (2004)
Install the master cylinder mounting nuts.
^
Tighten the nuts to 36 Nm (27 ft. lbs.).
5. For vehicles with JL4, remove the plug from the reservoir port and install the hose (4) and clamp (5) to the reservoir.
6. Remove the crimping tool from the hose (4).
7. Remove the rubber cap or plug from the exposed brake pipe fitting ends.
8. Connect the brake pipes.
^
Tighten the pipe fittings to 25 Nm (18 ft. lbs.).
9. Connect the electrical connector to the brake fluid level sensor.
10. Install the driver side upper fender support.
11. Bleed the hydraulic brake system.
12. Release the park brake and unblock the wheels.
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
