Savana 2500 2WD V8-5.3L VIN T (2004)
Ignition Cable: Service and Repair
SPARK PLUG WIRE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the engine cover.
2. Disconnect the spark plug wire at each spark plug.
-
Twist each spark plug wire 1/2 turn.
-
Pull only on the boot in order to remove the wire from each spark plug.
3. Disconnect the spark plug wire from the ignition coil.
-
Twist each spark plug boot 1/2 turn.
-
Pull only on the boot in order to remove the wires from the ignition coil.
Spark Plug Wire Length V8
-
The Melco(r) (square design) uses a spark plug wire (1) that is 145 mm (5.70 in) length cable seal to cable seal.
-
The Delphi(r) (round design) uses a spark plug wire (2) that is 110 mm (4.30 in) length cable seal to cable seal.