Savana 2500 2WD V8-5.3L VIN T (2004)
7. Scribe an alignment line between the pinion shaft and the pinion yoke.
8. Install the J8614-01 as shown.
9. Remove the pinion nut while holding the J8614-01.
Discard the pinion nut.
10. Remove the washer.
11. Install the J8614-2 (2) and the J8614-3 (3) into the J8614-01 (1) as shown.
12. Remove the pinion yoke by turning the J8614-3 (3) clockwise while holding the J8614-01 (1).
Use a container in order to retrieve the lubricant.
13. Remove the pinion oil seal using a suitable seal removal tool.
Installation Procedure