Savana 2500 AWD V8-5.3L VIN T (2004)
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Remove the side door trim plate. Refer to Door Trim Plate Replacement - Rear ().
2. Remove the side door pull handle screws.
3. Remove the side door pull handle.
4. Use the J 38778 to disengage the retainers around the outside edges of the lower portion of the door trim panel (1)
5. Carefully pull the door trim panel (1) out of the retainers around the window opening.
A long flat bladed tool may be necessary to aid in releasing the door trim panel (1) from the window opening retainers.
6. Remove the front door panel (1) from the vehicle.
Installation Procedure
1. Install the door trim panel (1) to the door by performing the following:
*
Align the door trim panel (1) to the retainers in the window opening.
*
Push towards the door to engage the retainers.
*
Align the retainers on the edges of the lower portion of the door trim (1).
*
Push towards the door to engage the retainers.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the pull handle and screws.
