Savana 2500 AWD V8-5.3L VIN T (2004)
3. Install the used crankshaft balancer bolt.
Tighten the USED crankshaft balancer bolt to 330 Nm (240 ft. lbs.).
4. Remove the used crankshaft balancer bolt.
Important: The nose of the crankshaft should be recessed 2.4–4.48 mm (0.094-0.176 inch) into the balancer bore.
5. Measure for a correctly installed balancer. If the balancer is not installed to the proper dimensions, install the J41665 and repeat the installation
procedure.
6. Install a NEW crankshaft balancer bolt.
1. Tighten the crankshaft balancer bolt a first pass to 50 Nm (37 ft. lbs.).
2. Tighten the crankshaft balancer bolt a second pass to 140 degrees using J45059.
7. Remove the J42386-A and bolts.
8. Install the starter motor.
9. Install the fan shroud - lower.
10. Install the accessory drive belt (if not equipped with A/C).
11. Install the A/C drive belt (if equipped).
12. Perform the Crankshaft Position (CKP) system variation learn procedure.