Savana 2500 AWD V8-5.3L VIN T (2004)
1. Install the new seal on the fuel tank.
IMPORTANT: The fuel strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender
assembly, assure that the fuel strainer does not block full travel of the float arm.
2. Install the fuel sender assembly into the fuel tank.
NOTE: Refer to the Fastener Notice in Service Precautions.
3. Install the retaining ring to the fuel sender assembly using the J 39765
4. Remove the fuel tank.
5. Refill the fuel tank.
6. Tighten the fuel filler cap.
7. Connect the negative battery cable.
8. Inspect for leaks:
8.1.
Turn ON the ignition for 2 seconds.
8.2.
Turn OFF the ignition for 10 seconds.
8.3.
Turn ON the ignition.
8.4.
Inspect for fuel leaks.
