Savana 2500 AWD V8-5.3L VIN T (2004)
Power Steering Fluid Reservoir: Service and Repair
Power Steering Reservoir Replacement - Off Vehicle
Power Steering Reservoir Replacement - Off Vehicle
Disassembly Procedure
1. Drain the power steering fluid from the power steering pump.
2. Remove the pump mounting studs (2).
3. Remove the connector and fitting assembly (4).
4. Remove the O-ring seal (3) from the connector and fitting assembly (4).
5. If replacement is required, remove the control valve assembly and the flow control spring from the pump housing assembly.
6. Remove the reservoir assembly (1) from the pump housing assembly (2).
7. Remove the O-ring seals (1), (4) and (5).
8. Remove the magnet (3).
9. Clean the magnet (3).
10. Inspect the welch plug in the power steering pump housing (2). Do not remove. If the welch plug is deformed or dislodged, replace the power
steering pump.
Assembly Procedure