Savana 2500 AWD V8-5.3L VIN T (2004)
^
Damage
^
Cracked connectors
^
Exposed wires
^
Loose pins
Installation Procedure
1. Install the wiring harness and TCC solenoid assembly with a new O-ring seal to the transmission.
2. Install the pass-through electrical connector to the transmission case.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the valve body bolts which retain the internal wiring harness and install the TCC solenoid retaining bolts.
^
Tighten the control valve body retaining bolts to 11 Nm (97 inch lbs.).
^
Tighten the TCC solenoid retaining bolts to 11 Nm (97 inch lbs.).
4. Install the pressure control solenoid.Ensure that the electrical tabs are facing outboard.
5. Install the pressure control solenoid retainer and retaining bolt.
^
Tighten the pressure control solenoid retaining bolt to 11 Nm (97 inch lbs.).