Savana 2500 AWD V8-5.3L VIN T (2004)
5. If replacing the right side seal and/or bearing, perform the following steps:
5.1.
Remove the inner shaft and housing assembly.
5.2.
Remove the inner shaft from the inner shaft housing.
5.3.
Install the inner shaft housing into a vise.
5.4.
Install the J29369-1 (2) to the backside of the seal or bearing as necessary.
5.5.
Install the J02619-1 (1) to the J29369- 1 (2).
5.6.
Remove the seal or the seal and bearing by pulling on the J02619-1.
Installation Procedure
1. If replacing the right side bearing, perform the following steps:
1.1.
Install the inner shaft housing into a vise.
1.2.
Install the bearing with the square shoulder in using the J42211 (2) and the J8092 (1).
2. If replacing the right side seal, perform the following steps:
2.1.
Install the inner shaft housing into a vise.
2.2.
Install the new inner shaft seal using the J42738.
Important: Carefully guide the inner shaft through the oil seal as to not to nick or cut the seal.