Savana 2500 AWD V8-5.3L VIN T (2004)
6. Remove the spider assembly (3).
7. Remove the tripot bushing (5).
8. Remove the tripot seal (6).
9. Clean the wheel drive shaft bar with a wire brush in order to remove any rust in the seal mounting areas.
Assembly Procedure
1. Slide the new clamps (4, 7) on the tripot seal (6).
2. Install the tripot seal (6) over the wheel drive shaft.
3. Install the tripot bushing (5) into the seal.
4. Slide the spider assembly onto the wheel drive shaft.
5. Install the new spider snap ring (2) with the J8059 or equivalent.
