Savana 3/4 Ton Van V6-4.3L VIN W (1998)
Hydraulic Brake Booster: Service and Repair
Alarm Switch Replacement
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
2. Disconnect the electrical connector from the fluid pressure alarm switch.
3. Remove the fluid pressure alarm switch from the vehicle.
INSTALLATION PROCEDURE
1. Install the fluid pressure alarm switch to the vehicle.
^
Tighten the fluid pressure alarm switch to 12 Nm (106 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Connect the negative battery cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
