Savana 3/4 Ton Van V6-4.3L VIN W (1998)
15. Reposition the power steering pump mounting bracket.
16. Install the three bolts and the nut for the power steering pump mounting bracket.
17. Install the front nut for the power steering pump rear bracket
^
Tighten the power steering pump mounting bracket bolts, the nut, and the power steering pump rear bracket nuts to 41 Nm (30 ft. lbs.).
18. Install the drive belt.
19. Install the ground wire to the water outlet stud.
^
Tighten the nut to 10 Nm (88 inch lbs.).
20. Connect the following electrical connectors:
^
The fuel meter body assembly
^
The EVAP canister purge solenoid valve
^
The Idle Air Control (IAC) motor
^
The Throttle Position (TP) sensor
^
The Manifold Absolute Pressure (MAP) sensor
^
The A/C compressor high pressure switch
^
The A/C clutch switch
^
The Exhaust Gas Recirculation (EGR) valve
^
The Engine Coolant Temperature (ECT) sensor
21. Install the accelerator control cable bracket, bolts, and nuts to the intake manifold and the throttle body.
^
Tighten the nuts and bolts to 12 Nm (106 inch lbs.).
22. Install the accelerator control cable to the throttle shaft.
23. Install the cruise control cable, if equipped.