Savana 3/4 Ton Van V6-4.3L VIN W (1998)
6. Remove and discard the crankshaft rear oil seal housing gasket.
7. Clean all sealing surfaces.
8. Inspect the crankshaft rear oil seal housing for warping, cracks, wear, or damage.
INSTALLATION PROCEDURE
1. Install a NEW crankshaft rear oil seal housing gasket.
2. Install the NEW crankshaft rear oil seal housing with the oil seal to the engine block using the following procedure:
IMPORTANT: When installing the NEW crankshaft rear oil seal housing the seal will come with the housing. Use the following procedure for
installing a new crankshaft rear oil seal housing.
2.1. Leave the sleeve in the crankshaft rear oil seal and use the sleeve as a guide to ease the seal lip over the end of the crankshaft
