Savana 3/4 Ton Van V6-4.3L VIN X (2003)
7. Install the shim washer (1) on the bottom of the distributor shaft.
8. Install the tang washer.
9. Install the round washer.
10. Install the driven gear according to the index marks.
11. Align the rotor segment as shown for a V6 engine (1) or V8 engine (2).
12. Install the gear and align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).
13. Check to see If the driven gear is installed incorrectly, the dimple will be approximately 180 degrees opposite the rotor segment when it is
installed in the distributor.
14. Support the distributor drive gear in a V-block or similar fixture.
CAUTION: Refer to Safety Glasses Caution in Service Precautions.
15. Install the roll pin with a suitable punch and hammer in order to hold the driven gear in the correct position.
