Savana 3/4 Ton Van V6-4.3L VIN X (2003)
Accelerator Pedal: Service and Repair
ACCELERATOR CONTROL PEDAL REPLACEMENT
REMOVAL PROCEDURE
1. Lift upward on the accelerator pedal (3) to relieve the tension on the cable (2).
2. Remove the retainer (1) from the pedal lever (4) hole.
3. Remove the cable from the slot in the pedal lever.
4. Remove the accelerator pedal mounting fasteners.
5. Remove the accelerator pedal assembly.
INSTALLATION PROCEDURE
IMPORTANT: The accelerator cable is not to be kinked or damaged in any way during installation.
Ensure that the mounting surface between the accelerator pedal assembly and the dash panel is free of insulation. The carpet and padding in the pedal
area must be positioned to lay flat and free of wrinkles and bunches. Wires, hoses, cables, and other flexible components should not be within 13 mm
(0.52 in) of the cable or lever, at any point in their travel.
1. Place the accelerator pedal assembly (4) on the mounting surface.
2. Install the mounting bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the pedal assembly to 5 N.m (44 lb in).
3. Lift upward on the accelerator pedal (3).
4. Insert the cable (2) through the pedal lever slot.
