Savana 3/4 Ton Van V6-4.3L VIN X (2003)
Fuel: Testing and Inspection
With Special Tool
TEST DESCRIPTION
Water contamination in the fuel system may cause driveability conditions such as hesitation, stalling, no start, or misfires in one or more cylinders.
Water may collect near a single fuel injector at the lowest point in the fuel injection system and cause a misfire in that cylinder. If the fuel system is
contaminated with water, inspect the fuel system components for rust or deterioration.
Alcohol concentrations of 10 percent or more in the fuel can be detrimental to fuel system components. Alcohol contamination may cause fuel system
corrosion, deterioration of rubber components, and subsequent fuel filter restriction. Some types of alcohol are more detrimental to fuel system
components than others. Ethanol is commonly used in gasoline, but in concentrations of no more than 10 percent. Some fuels, such as E85, contain a
very high percentage of ethanol. Fuel with more than 10 percent ethanol may cause driveability conditions such as hesitation, lack of power, stalling,
or no start.
TEST PROCEDURE
1. Turn ON the J 44175 Fuel Composition Tester.
2. Verify the fuel composition tester is operational by measuring the AC frequency output with a DMM. Refer to Measuring Frequency in Diagnostic
Aids. A frequency without a fuel sample in the test cell indicates that the tester is working correctly.
3. Install the fuel pressure gage.
4. Close the bleed valve on the fuel pressure gage.
IMPORTANT: Bleed the fuel pressure gage a few times in order to obtain an accurate fuel sample from the vehicle being tested.
5. Place the bleed hose (1) of the fuel pressure gage into the 100 ml beaker (2).
6. Command the fuel pump relay ON with a scan tool.
7. Slowly open the bleed valve on the fuel pressure gage, until an adequate fuel sample is obtained.
8. If water appears in the fuel sample, clean the fuel system and replace the fuel in the vehicle.
