Savana 3/4 Ton Van V6-4.3L VIN X (2003)
3. Connect the chassis fuel return pipe to the rear fuel return pipe.
4. Connect the fuel feed pipe to the fuel filter.
5. Lower the vehicle.
6. Refill the fuel tank.
7. Tighten the fuel filler cap.
8. Connect the negative battery cable.
9. Inspect for leaks:
9.1.
Turn ON the ignition for 2 seconds.
9.2.
Turn OFF the ignition for 10 seconds.
9.3.
Turn ON the ignition switch.
9.4.
Inspect for fuel leaks.
10. Install the engine cover.
Chassis (Engine to Fuel Filter)
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Disconnect the fuel feed and return pipes (3) from the engine compartment fuel pipes (4).
4. Remove the fuel pipes from the bellhousing stud retainer clip.
5. Raise the vehicle. Refer to Vehicle Lifting.
6. Disconnect the fuel feed pipe at the fuel filter.
7. Disconnect the chassis fuel return pipe at the rear fuel return pipe.
8. Remove the fuel pipe retaining clips. Note the location of the retaining clips for installation.
9. Remove the fuel feed and return pipes.
INSTALLATION PROCEDURE
1. Position the fuel feed and return pipes in the vehicle.
