Savana 3/4 Ton Van V6-4.3L VIN X (2003)
2. Install the fuel pipe retaining clips (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the clips to 12 N.m (106 lb in).
3. Connect the chassis fuel return pipe (4) to the rear fuel return pipe.
4. Connect the fuel feed pipe (5) to the fuel filter.
5. Lower the vehicle.
6. Install the fuel feed and return pipes to the engine compartment fuel pipes.
Tighten
Tighten the fuel pipe fittings to 27 N.m (20 lb ft).
7. Install the fuel pipes to the retainer clip.
Tighten
Tighten the fuel pipe retainer clip nut to 28 N.m (21 lb ft).
8. Tighten the fuel filler cap.
9. Connect the negative battery cable.
10. Inspect for leaks:
10.1. Turn ON the ignition for 2 seconds.
10.2. Turn OFF the ignition for 10 seconds.
10.3. Turn ON the ignition.
10.4. Inspect for fuel leaks.
11. Install the engine cover.
Chassis (Filter to Tank Cutaway Van Side Tank)
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Remove the fuel tank.
