Savana 3/4 Ton Van V6-4.3L VIN X (2003)
CAUTION: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket
when reinstalling the fuel sender assembly.
2. Install the fuel sender assembly into the fuel tank.
IMPORTANT: The fuel strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender
assembly, assure that the fuel strainer does not block full travel of the float arm.
3. Install the retaining ring to the fuel sender assembly using the J 39765
NOTE: Refer to the Fastener Notice in Service Precautions.
4. Remove the fuel tank.
5. Refill the fuel tank.
6. Tighten the fuel filler cap.
7. Connect the negative battery cable.
8. Inspect for leaks:
8.1.
Turn ON the ignition for 2 seconds.
8.2.
Turn OFF the ignition for 10 seconds.
8.3.
Turn ON the ignition.
8.4.
Inspect for fuel leaks.
