Savana 3/4 Ton Van V6-4.3L VIN X (2003)
Ignition Coil: Service and Repair
REMOVAL PROCEDURE
1. Remove the engine cover.
2. Disconnect the ignition coil electrical connectors.
3. Remove the ignition coil wire to the distributor.
4. Remove the accelerator cable bracket.
5. Remove the studs holding the bracket and the ignition coil to the intake manifold.
6. Remove the bracket and the ignition coil.
7. Drill and punch out the two rivets holding the ignition coil to the bracket.
8. Remove the ignition coil from the bracket.
INSTALLATION PROCEDURE
1. Install the ignition coil to the bracket with the 2 screws.
IMPORTANT: A replacement ignition coil kit comes with 2 screws in order to attach the ignition coil to the bracket.
