Savana 3/4 Ton Van V6-4.3L VIN X (2003)
INSTALLATION PROCEDURE
IMPORTANT: When installing the CKP sensor, make sure the sensor is fully seated before tightening the mounting bolt. A poorly seated CKP
sensor may perform erratically and may set false DTCs.
1. Replace the CKP sensor O-ring.
IMPORTANT: Do not use the original O-ring.
2. Lubricate the O-ring with clean engine oil before installing the CKP sensor.
3. Install the CKP sensor.
IMPORTANT: Make sure the CKP sensor mounting surface is clean and free of burrs.
4. Install the CKP sensor mounting bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the mounting bolt to 8 N.m (71 lb in).