Savana 3/4 Ton Van V6-4.3L VIN X (2003)
7.
Remove the two screws (2) for the passenger side knee bolster trim panel and remove the panel (1).
8.
Remove the two bolts supporting the steering column and carefully lower the column.
9.
Place the gearshift lever in a low gear.
10.
Carefully pull the instrument panel bezel in the sequence listed to release the retaining clips.
1.
Pull on the bottom.
2.
Pull at the left corner.
3.
Pull at the right corner.
4.
Pull at the top.
11.
Disconnect the necessary electrical connectors from the rear of the bezel and remove the bezel.
12.
Remove the AIR BAG switch from the bezel.
13.
Install the "blank" panel into the bezel in place of the AIR BAG switch.
Important
The purpose of the adhesive in the next step is to disable the switch so that it can't be operated with a key. It is NOT necessary to wait for the
adhesive to cure before reinstalling.
14.
With the AIR BAG switch in the ON position, apply the adhesive into the key cylinder opening in the switch.
15.
Reconnect the electrical connector to the AIR BAG switch and apply foam tape around the switch to prevent rattles.
16.
Position the switch and wiring into the recessed opening in the instrument panel and secure with tape as necessary.
17.
Connect any necessary electrical connectors to the bezel.
