Savana 3/4 Ton Van V6-4.3L VIN X (2003)
7.
Reinstall the idler arm and bolts and tighten just the top bolt.
8.
Reinstall the idler arm to the relay rod and tighten the nut.
Tighten
Tighten the nut to 63 N.m (47 lb ft).
9.
With the aid of an assistant, rotate the idler arm clockwise to make the adjustment of 14 mm (0.55 in) and tighten the bottom bolt.
Tighten
Tighten the bolts to 150 N.m (111 lb ft).
10.
Loosen the three steering gear box bolts.
11.
With the aid of an assistant, rotate the gear box counterclockwise to gain the adjustment of 14 mm (0.55 in) and tighten the three bolts.
Tighten
Tighten the bolts to 150 N.m (111 lb ft).
Important:
Side to side measurement should not exceed 4 mm (0.16 in). See the chart shown.
12.
Install the sway bar.
Tighten
Tighten the sway bar nuts and bolts to 46 N.m (34 lb ft).
13.
Install the engine protection shield.
Tighten
Tighten the bolts to 20 N.m (15 lb ft).
14.
Place the vehicle on an alignment rack and check the toe.
Warranty Information