Savana 3/4 Ton Van V6-4.3L VIN X (2003)
1. Install J37623 (2) onto propeller shaft (1) at weld shoulder (3) with taper of tool pointing away from the splined stub shaft.
2. Support the J37623 (6) in the press (5) with the stub shaft (2) vertical.
3. Place the center bearing assembly (3) on the propeller shaft with the circular can (4) towards the weld shoulder.
4. Install the J25234 (1) onto the shaft.
Ensure the J25234 (1) is resting on the inner race of the center bearing.
Important: During the next step, care should be exercised to prevent damage to the center bearing assembly, the journal of the propeller shaft, and
the plastic coated splined stub shaft.
5. Press on top of the J25234 (1) until center bearing assembly (3) is fully seated.
6. The gap (4) between circular can (2) and propeller shaft (3) should be approximately 4.0 mm (0.157 inch).
