Savana 3/4 Ton Van V8-5.3L VIN T (2003)
Antenna Cable: Service and Repair
Antenna Cable Replacement
ANTENNA CABLE REPLACEMENT
REMOVAL PROCEDURE
1. Unscrew and remove the antenna mast (1).
2. Disconnect the antenna base cable connection from the antenna extension cable.
3. Push the antenna base cable grommet (5) out, through the firewall.
4. Open hood to access the antenna cable/base (3).
5. Remove the antenna collar (2).
6. Remove the antenna cable/base bolts (4).
7. Remove the antenna cable/base (3) from the vehicle.
INSTALLATION PROCEDURE
1. Install the fixed antenna cable/base (3).
2. Install the antenna cable/base mounting bolts (4).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the antenna cable/base mounting bolts (4) to 11 N.m (97 lb in).
3. Route the antenna base cable under the A/C case and through the hole in the firewall.
4. Install the antenna cable grommet (5) through firewall and seat the grommet (5).
5. Install the antenna collar (2).
6. Connect the antenna base cable to the antenna extension cable.
7. Install the passenger side hinge pillar trim.
