Savana 3/4 Ton Van V8-5.3L VIN T (2003)
6. Disconnect the accelerator control cable and the cruise control cable from the throttle body, if equipped.
7. Remove the upper engine wire harness retainer nut.
8. Disconnect the evaporative emission (EVAP) purge valve harness connector.
9. Reposition the upper engine wire harness aside.
10. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
11. Mark the electrical connectors to their corresponding injectors to ensure correct sequential injector firing order after reassembly.
IMPORTANT: When disconnecting the Multec 2 fuel injector connectors, DO NOT use pliers or other hand tools, as the connector ends may
become mangled and be rendered unusable.
