Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
3. Align the channel on the rear door opening weather-strip with the pinch-weld flange.
Important: When installing the rear door opening weather-strip, ensure that the corners have not pulled away from the body.
4. Press the weather-strip into place. If you are reinstalling the original weather-strip, use GM weather-strip adhesive GM P/N 12345097, or
Canadian P/N 10953479 at the bottom ends of the rear door opening weather-strip in order to retain the weather-strip to the body.
5. Install the retainers in the ends of the rear door opening weather-strip into the holes in the floor panel.
6. Install the rear door frame garnish molding. Refer to Rear Door Opening Frame Garnish Molding Replacement () .
7. Install the rear floor trim plate. Refer to Rear Floor Trim Plate Replacement (See: Interior Moulding / Trim/Scuff Plate/Service and Repair) .
8. Install the right rear corner trim panel. Refer to Body Rear Corner Trim Panel Replacement - Right Side (See: Interior Moulding / Trim/Trim
Panel/Service and Repair/Body Rear Corner Trim Panel Replacement - Right Side) in Interior Trim.
9. Install the driver side body side rear trim panel. Refer to Body Side Rear Trim Panel Replacement (See: Interior Moulding / Trim/Trim
Panel/Service and Repair/Body Side Rear Trim Panel Replacement) in Interior Trim.
10. Install the rear corner garnish molding. Refer to Body Rear Corner Garnish Molding Replacement (See: Interior Moulding / Trim/Trim
Panel/Service and Repair/Body Rear Corner Garnish Molding Replacement) in Interior Trim.
