Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
Center Sliding Door Rail: Service and Repair
Roller Track Replacement - Sliding Door Center (Center)
Removal Procedure
1. Remove the passenger side body side trim panel. Refer to Body Side Trim Panel Replacement - Right Side (See: Interior Moulding / Trim/Trim
Panel/Service and Repair/Body Side Trim Panel Replacement - Right Side) in Interior Trim.
2. Remove the sliding side door lower trim panel. Refer to Sliding Door Lower Trim Panel Replacement (See: Sliding Door Interior Trim
Panel/Service and Repair/Trim Panel Replacement - Sliding Door Lower) .
3. Remove the sliding side door center track stop nuts and washers from the vehicle.
4. Remove the sliding side door center track stop from the vehicle.
5. Remove the sliding side door center track cap nut and plate from the vehicle.
6. Remove the sliding side door center track cap from the vehicle.
7. Remove the sliding side door center roller bracket. Refer to Rear Side Door Center Roller Bracket Replacement (See: Center Sliding Door
Roller/Service and Repair) .
8. Remove the nuts and the washers that retain the sliding side door center track to the body.
9. Remove the sliding side door center track from the vehicle.
Installation Procedure
1. Install the sliding side door center track to the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the nuts and the washers that retain the sliding side door center track to the body.
Tighten the nuts to 11 N.m (97 lb in).
3. Install the sliding side door center roller bracket. Refer to Rear Side Door Center Roller Bracket Replacement (See: Center Sliding Door
Roller/Service and Repair) .
4. Install the sliding side door center track cap to the vehicle.
5. Install the cap nut and plate that retains the sliding side door center track to the vehicle.
Tighten the nut to 25 N.m (18 lb ft).
6. Install the sliding side door center track stop to the vehicle.
7. Install the nut and washer that retains the sliding side door center track stop to the vehicle.
