Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
Compressor Clutch: Service and Repair
COMPRESSOR CLUTCH PLATE/HUB ASSEMBLY REPLACEMENT
TOOLS REQUIRED
^
J 34992 Compressor Holding Fixture
^
J 33013-B Hub and Drive Plate Remover/Installer
^
J 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Remove the air compressor from the vehicle.
2. Use the J 34992 in order to install the compressor in the vise.
3. Use both thumb screws in order to attach the compressor to the J 34992.
4. Remove the shaft protector from the clutch hub shaft.
NOTE: Do not drive or pound on the clutch hub or shaft. Internal damage to the compressor may result. The forcing tip on the J 33013-B
remover/installer center screw must be flat or the end of the shaft/axial plate assembly will be damaged.
5. Ensure that the center screw forces the tip to thrust against the end of the shaft.
6. Thread the J 33013-B into the hub.
7. While holding the body of the J 33013-B of the remover with a wrench, turn the center screw into the remover body in order to remove the clutch
plate and hub assembly (1).
8. Remove the shaft key (4). Retain the shaft key for reassembly.
9. Remove the old clutch plate and hub assembly from the compressor.
INSTALLATION PROCEDURE
