Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
Air Bag(s) Arming and Disarming: Service and Repair
Enabling
1. Remove the key from the ignition.
2. Connect the IP module yellow 2-way connector located under the instrument panel extension.
3. Install the Connector Position Assurance (CPA) to the IP module yellow 2-way connector.
4. Install the passenger knee bolster.
5. Connect the steering wheel module yellow 2-way connector located at the base of the steering column.
6. Install the CPA to the steering wheel module yellow 2-way connector located at the base of the steering column.
7. Install the driver knee bolster.
8. Install the AIR BAG Fuse to the IP fuse block.
9. Staying well away from both air bags, turn ON the ignition, with the engine OFF.
9.1.
The AIR BAG indicator will flash 7 times.
9.2.
The AIR BAG indicator will then turn OFF.
10. Perform the Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described. See: Restraint Systems/Air Bag
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
