Savana 3/4 Ton Van V8-6.5L DSL Turbo VIN F (2001)
Fog/Driving Lamp Switch: Service and Repair
Fog Lamp Switch Replacement - Front (Luxury Y91)
REMOVAL PROCEDURE
1. Remove the Instrument Panel (IP) trim-plate bezel from the IP.
2. Disconnect the electrical connector from the fog lamp switch.
3. Using a small flat-bladed tool, carefully release the retaining tabs (1) that connect the fog lamp switch to the IP trim-plate bezel.
4. Remove the fog lamp switch (2) from the IP trim-plate bezel.
INSTALLATION PROCEDURE
1. Align the fog lamp switch (2) to the IP trim-plate bezel. Press into place.
2. Connect the electrical connector to the fog lamp switch.
3. Install the IP trim-plate bezel.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes